青青草原av在线免费,亚洲最大最淫熟女网五十路,国产va亚洲vaxxoo,99久久免费观看黑人精品,国产av丝袜美腿视频一区,中国黄色av一级片,亚洲mv在线观看视频,毛片黄页网站在线观看,成人午夜黄色免费网站

1、首先在選購時要注意生產企業的廠名、廠址、商標是否齊全。
1, we should pay attention to when choosing the name and address of the manufacturer, the trademark production enterprises are complete.
因為只有標識齊全的板材才能得到應有的質量保證。
Because only the plate can get the proper quality assurance.
2、表面無明顯瑕疵。
2, surface no obvious defects.
板材表面應光潔、無毛刺溝痕和刨刀痕，無透膠現象，板面無局部發黃、發黑等污染現象。
Plate surface should be smooth, without burr grooves and planer marks and without penetrating the phenomenon of rubber, the surface without local yellow, black and other pollution phenomenon.
3、區分人造和天然貼面。
3, distinguish between artificial and natural veneer.
通常人造薄木單板貼面的紋理基本為通直紋理，紋理圖案有規則; 而天然木質單版貼面為天然木質花紋，紋理圖案自然而無規則，變異性比較大。

Usually artificial veneer veneer texture is straight grain, texture pattern rules; and natural wood single plate veneer natural wood patterns, texture pattern naturally without any rules, variability is relatively large.

4、無開膠現象。
4, no glue phenomenon.
膠和強度充分反映了板材膠合性能的優劣，膠合強度值約高，膠合性能就越好。 在選擇板材時，應注意裝飾板膠層結構穩定、無開膠現象。仔細觀察，在表面單版與基材之間、基材內部各層之間不能出現鼓包、分層現象。
Fully reflects the strength and adhesive bonding performance of sheet metal quality, higher bonding strength value, the better the performance bond. In the choice of plate, should pay attention to decorative plate layer structure is stable, without glue phenomenon. Careful observation, in the surface between the single version and the substrate, the substrate between the layers can not occur between the drum package, layered phenomenon.
5、氣味應清淡。
5, the smell should be light.
裝飾板使用的膠粘劑以脲醛樹脂為主，裝飾板材經加工處理后，材質中會遺留有少量甲醛，并逐漸釋放。這種氣味對人體極為有害。 在選購時，可從氣味來判斷，因為氣味越大，說明甲醛釋放量越高，污染越厲害，其危害性就越大。
Decorative plate using the adhesive to urea formaldehyde resin based, decorative plate after processing, the material will be left with a small amount of formaldehyde, and gradually released. This smell is very harmful to the human body. In the purchase, you can judge from the smell, because the greater the smell, the higher the formaldehyde emissions, the more serious pollution, the greater the risk.
6、注意含水率。
6, pay attention to moisture content.
通常裝飾單版貼面膠合板要求有一定的含水率，其含水率越接近使用地區的平衡含水率越好。 含水率過高或過低，裝飾板都會在環境溫度變化影響下出現較大的變形。因此，在溫度比較小的地區，適宜使用含水率較低的裝飾板;反之，則應使用含水率較高的裝飾板。
Veneer plywood is usually decorated with a certain percentage of moisture content, the water content of the more close to the use of the region's water balance, the better. The water content is too high or too low, the decorative board will be under the influence of environmental temperature changes appear larger deformation. Therefore, the temperature is relatively small, suitable for the use of lower water content of the decorative plate; otherwise, should use a higher water content of the decorative board.
7、觀察紋理結構。
7, observe the texture structure.
在其他項都滿意的情況下，還要注意材質應細致均勻、色澤清晰、木紋美觀。配板與拼花的紋理應按一定規律排列，且木色相近，無明顯色差，拼縫與板邊近乎平行。這樣的板材才能收到很好的裝飾效果。
The other items are satisfied with the situation, but also pay attention to material should be uniform, clear and beautiful wood color. With the plate and mosaic texture should be regular, and the wood color similar, no obvious color difference, and nearly parallel plate edge seam. Such plates can receive a good decorative effect.